Buy ASTM D CLASSIFICATION FOR MACHINE-MADE ‘ FIBERGLASS’ (GLASS-FIBER-REINFORCED THERMOSETTING-RESIN) PIPE from SAI. Find the most up-to-date version of ASTM D at Engineering This classification covers machine-made “fiberglass” (glass-fiber-reinforced thermosetting-resin) pressure pipe. Methods of classification.
Our asym is too poor to buy the latest version D ; therefore, this designation code generator is based on ASTM D data which is probably what many manufactures use.
The outside diameter of the? Or the D Table 1 data can be used to explain how the classification designation code for composite fiberglass piping is derived.
Benton, Ar Cell: NOTE 3—All possible pressure strength d23310 of types, grades, and classes may not be commercially available.
The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
Description of Terms Speci? Precedence for this change has been made in other ASTM standards. Formerly under the jurisdiction of Committee D20 on Plastics, this standard was withdrawn in August Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. The manufacturer should be consulted. Individual reprints single or multiple copies of this standard may d231 obtained by contacting ASTM at the above address or at phonefaxor service astm.
The values in parentheses are provided for information only.
The manufacturer should be consulted. B Refer to Practice D to obtain classification of the values. A number in parentheses indicates the year of last reapproval. The inside diameter of the pipe is determined by the amount of material introduced into the mold.
This standard does not purport to address all of the safety concerns, if any, associated with its use. This cell-type format, however, is subject to misapplication since unobtainable property combinations can be selected if the user is not familiar with commercially available products.
Note 1 — For the purposes of this standard, polymer does not include natural polymers. Standard categories for the hydrostatic design basis are shown in Table 1.
Methods of classification, requirements, test methods and the method of marking are included. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. The values in parentheses are provided for information only.
A superscript epsilon e indicates an editorial change since the d231 revision or reapproval. NOTE 5—Information regarding selection of service design factors and pressure rating is provided in Practice D and the individual product standards.
A hydrostatic design basis as shown in Table 1 shall be determined for each type, grade, and class of product manufactured. Table 1 data was divided into 4 D23100 for spacing considerations.
Last previous edition D — This standard has been approved for use by agencies of the Department of Defense.
Note 2 — There is no known ISO equivalent to this standard. It is not based on dimensions or raw material specifications. Two methods of classifying long-term strength are included: It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. Link to Active This link will always route to the current Active version of the standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Stay on Page Continue to Compass.
The inside diameter of the?
Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. Table 1 presents a summary of the designation requirements. For the second generator, the property must be supplied by the FRP fiberglass pipe manufacturer in order to generate the ASTM D designation code satm the piping.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?