pdf instructions. Find the office and computer equipment manual you need at ManualsOnline. Symbol Technologies DS Scanner User Manual. Page 1. SYMBOL DS RS USB. 3. 2. 1 SYMBOL DS CODES À BARRES DE PARAMÈTRAGE . Symbol ds digital scanner • Read online or download PDF • Motorola DIGITAL DS User Manual.
Model 2 symbol, ECI protocol implemented. Center the symbol in the aiming pattern. With this interface, the digital scanner is connected between the keyboard and host computer, and translates bar code data into keystrokes.
Keyboard Wedge Interface 11 – 3 Turn off the host and unplug the keyboard connector. Scanner decoding bar code, but data not transmitting to host. When enabled, mabual device connects to the same COM port.
Motorola DS6708 Product Reference Manual
In this way, customers using Symbol compliant decoders can control the behavior of the entire system by scanning the necessary parameters only once. Introduction Chapter 1 Getting Started Introduction The Symbol DS combines superior 1D and 2D omnidirectional mankal code scanning and sub-second image capture and transfer to provide the best value in a digital scanner.
Scanner Emulation Interface 10 – 9 Transmission Timeout The Scanner Emulation host transmits bar code data to the attached decoder and waits for the decoder to assert the Decode signal, indicating successful transmission.
The settings are stored in non-volatile memory and are preserved even when the digital scanner powers down. Do not dw6708 any code length to select code types of any length.
Motorola Symbol DS6708 Quick Start Manual
Upon successful decode, the digital scanner beeps and the LED turns green. Use the RS interface to connect the digital scanner to point-of-sale devices, host computers, or other devices with an available RS port e.
Keyboard Wedge Interface 11 – 7 Ignore Unknown Characters Unknown characters are characters the host does not recognize. Scan manuual appropriate bar code below to transmit the bar code data with or without the UPC-A check digit.
To accomplish this, the I 2 of 5 code must be enabled, and the code must have a leading zero and a valid EAN check digit. For example, to decode Code 93 symbols containing between 4 and 12 characters, first scan Code 93 – Length Within Range.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
If the system power is interrupted the data is not be lost. The following options are available: Page Index – 3 code Move the scanner forward until there is full access to the cable interface port on the bottom of the scanner.
To allow compatibility in these environments, the digital scanner converts these code types to more commonly decodable symbologies, as per the following chart. If software handshaking and hardware handshaking are both enabled, hardware handshaking takes precedence.
For more information on beeper The Symbol logo is a registered trademark of Symbol Technologies, Inc. Unknown characters are characters the host does not recognize. To change any option, scan the appropriate bar code s in the Keyboard Wedge Host Parameters section beginning on page The exact or ideal intended value for a specified parameter.
RS Interface 7 – 3 Connect the other end of the RS interface cable to the serial port on the host.
MOTOROLA SYMBOL DS QUICK START MANUAL Pdf Download.
A warm boot restarts the mobile computer by closing all running programs. There are two ways to change the default values: Set lengths for D 2 of 5 to manuaal length, one or two discrete lengths, or lengths within a specific range. Connect the other end of the Scanner Emulation interface cable to the scanner port on the mobile computer or controller. Attach the modular connector of the Y-cable to the cable interface port on the digital scanner. Set the digital scanner’s baud rate to match the baud rate setting of the host device.
The data can be used for age verification, credit card application information and more. Enter text from picture: