HONDA OUTBOARD OWNERS MANUAL PDF

  • June 21, 2019

Honda outboard service/repair manual – Seloc | 4-stroke | 4 stroke | Table of Contents PDF file | 2 hp – hp – 4 hp – 8 hp – 40 hp – 50 hp – 75 . Clymer Honda Outboard Marine service and repair manuals are written with model specific coverage for your Honda Outboard Marine. From basic service and. View and Download Honda Outboard Motor BFA owner’s manual online. Honda Power Equipment Outboard Motor Owner’s Manual. Outboard Motor.

Author: Mezile Taujora
Country: Austria
Language: English (Spanish)
Genre: Technology
Published (Last): 26 February 2011
Pages: 27
PDF File Size: 12.47 Mb
ePub File Size: 17.70 Mb
ISBN: 833-2-45202-660-2
Downloads: 67994
Price: Free* [*Free Regsitration Required]
Uploader: Basho

Fast idle lever cannot be raised unless the control lever is in the N neutral position.

To stop the engine in an emergency, pull the clip out of the emergency stop switch by pulling the lanyard. This feature enables the outboard motor to be tilted or lowered when no battery is connected.

There are two anodes on the gear case, one on the stern bracket, and two small anodes in the water passages of the engine block. Failure to properly follow maintenance instructions and precautions can cause The control lever automatically locks itself in the N neutral position.

Honda Marine | Owners’ Manuals

The tilt lock lever is used to support the outboard motor in the fully-raised position. Panel-mount Type The emergency stop switch clip and lanyard system is a safety device that will stop the engine if you fall away from the controls while operating the boat.

When the engine starts, release the key, allowing it to return to the ON position. Problems That May Af f ect Emissions If you are aware of any of the following symptoms, have your engine inspected and repaired by your servicing dealer. The engine will not start if the F forward or R reverse gears are engaged. Comments to this Manuals Your Name.

Handle fuel only outdoors. The switch clip must be inserted in the emergency stop switch in order for the engine to start and run. Check to be sure there are no fuel leaks before starting the engine. The propeller blades may have sharp edges, so wear heavy gloves to protect your hands. Disconnect the outboard motor from the boat, hoist the outboard motor, and move it to the storage area.

  FR A024 PDF

Owner’s Manuals

Ownets lever not in neutral position. When the boat is to be moored for a long time, tilt the outboard motor as far as it will go. This manual also for: Loosen the vapor separator drain screw. To meet clean air standards, some areas of the United States and Canada use oxygenated fuels to help reduce emissions.

This shows that water is circulating through the cooling system. Remove hodna old fuse by removing two 5 mm screws. If there is still no water flowing from the cooling system indicator, or if the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer. Replace the anodes when they have oitboard reduced to about half their original size, or if they are crumbling.

HONDA OUTBOARD MOTOR BFA OWNER’S MANUAL Pdf Download.

Stop mabual engine and keep heat, sparks, and flame away. Damage to the power tilt system may occur. Water accumulation in the water separator can cause loss of power or hard starting.

If the gasoline in your fuel tank and vapor separator deteriorates during storage, you may need to have the vapor separator and other fuel system components serviced or replaced. Refueling Insert the mud guard clips with the inner part raised off, then push in the inner part securely until they click. Adjust the trim tab in small increments, and retest steering effort with the boat evenly loaded and running at cruising speed.

Fast Idle Button The switch clip must be inserted in the emergency stop switch in order for the engine to start and run.

  INTRODUCCION A LA COMPUTACION GEORGE BEEKMAN PDF

Page outboare Congratulations on your selection of a Honda outboard motor. We suggest that you stop the engine this way occasionally to verify that the emergency stop switch is operating properly. Always stop the engine if you must leave the controls for any reason.

Refer to Less friction allows easier control lever movement. Bad fuel; boat stored without treating or draining gasoline, or refueled with bad fuel.

If ownees is accumulated, stop the engine, and clean outobard water separator following the instructions on pageor consult with an authorized Honda marine dealer. The outboard motor is supplied with spare fuses in the fuse holder. Control of hydrocarbons and oxides of nitrogen is very important because, under certain conditions, they react to form photochemical smog when subjected to sunlight.

Then move the tilt Wipe up any spills before starting the engine. Improperly maintaining this outboard motor, or failure to correct a problem before operation, can cause a malfunction in which you could be seriously hurt or killed. Thoroughly clean the strainer cup, and replace with a new fuel filter.

Page 96 If there is still no water flowing from the cooling system outboaed, or if the engine protection system remains activated after 30 seconds, return to the nearest boat landing, and have the outboard motor inspected by an authorized Honda marine dealer. Possible Cause Fast manuual lever raised side-mount type. Refuel carefully to avoid spilling fuel.

After the first 20 hours or 1 month, then every hours or 6 months.

Remove the fuse case lid.