IC MCT2E DATASHEET PDF

  • June 20, 2019

MCT2 and MCT2E are also available in white package by . MCT2E. MCT2E-M. MCT V. (IC = 16 mA, IF = 32 mA, TA = °C). Details, datasheet, quote on part number: MCT2E Collector-emitter saturation voltage Input-to-output internal resistance TEST CONDITIONS = 10 µA, IC =1. MCT2E ON Semiconductor / Fairchild Transistor Output Optocouplers DIP-6 PHOTO TRANS datasheet, inventory & pricing.

Author: Shaktitilar Gutilar
Country: Egypt
Language: English (Spanish)
Genre: Software
Published (Last): 27 April 2012
Pages: 97
PDF File Size: 5.80 Mb
ePub File Size: 15.18 Mb
ISBN: 978-1-32682-725-9
Downloads: 40489
Price: Free* [*Free Regsitration Required]
Uploader: Yojind

There pull-up resistor 1K acts as a load resistor.

Another important parameter to consider while using an Optocoupler, is the rise time tr and fall time tf. The output will not get high as soon as the input logic is made low and vice versa.

But when the Logic input is made high, this high voltage should be a minimum of 1. This comes in very handy when you are trying to isolate a noisy signal ci your digital dwtasheet, so if you are looking for an IC to provide optical isolation in your circuit design then this IC might be the right choice for you.

  FISIOLOGIA HUMANA ARTHUR C.GUYTON PDF

When the IR led is powered the light from it falls on the transistor and it conducts.

MCT2E IC Pinout, Specifications, Equivalent, Working & Datasheet

In the Photo-transistor mode we will not be using the base pin pin 6 of dataeheet transistor; we just have to connect the anode pin of the IR LED pin 1 to the logic input which has to be isolated and the cathode pin 2 of the IR led to the ground.

This is the logic output pin 6 Base B Base pin of the Transistor.

The complete working can also be understood form the GIF file above. The ground line of the IR LED pin 2 and the ground line of the transistor pin 4 will not datashedt connected together. The digital signal given to the IR LED will be reflected on the transistor but there will be no hard electrical connection between the two. The below waveform shows the time taken for the output to transit from one datasheeet to another. Connected to isolated ground.

Submitted by admin on 7 March Out of which the Phototransistor mode is mostly used, so let us datashheet at that mode first. This IC is used to provide electrical isolation between two circuits, one part of the circuit is connected to the IR LED and the other to Photo-transistor.

  EVOLUTION DECEIT HARUN YAHYA PDF

IC MCT2E Optocouplers

Then Pull high the collector pin of the transistor using a resistor here I have used 1K and connect the collector pin to the output of your desired logic circuit. This way the logic input will be reflected at the logic output and still provides and isolation between the two. More details can be found at the MCT2E datasheet which is available for download at the end of this page.

TL — Programmable Reference Voltage. It is normally not used for transistor mode, but will be used in diode mode. The Emitter pin 4 is grounded. This will short the collector and emitter and hence the Logic Output voltage will become zero.

This is where the isolation occurs. Base pin of the Transistor.